專機精密儀器有限公司 - Lane 182

Very good precision

Professional testing machine and special machine manufacturing

Bad company ㄧ room ..... commissioning our company for foundry! Ask us to help him insert the bill ..... After finishing it ... it was too expensive there ... and still owed money ... calling to ask the accountant for leave ... the boss is not there. .. a bad company ... I ’m going to take legal action

After receiving the machine, I found a pile of cigarette butts and soot, and the service attitude was poor, and the things had always been problematic, and the engineers were asked to repair them. The engineers were straightforward and the technology was also very poor. If things were wrong, they would look down on people. The parts are inferior products imported from the mainland.

Bad technology and bad service !! If you want to find them, You must have a good technical foundation ~ be patient and invincible The two machines and molds that our company bought here cost about 700,000 yuan. During the pre-purchase meeting, boss Liu talked about smallpox. In response to our demand, we all say "no problem". Then there was a series of delivery delays. The first thing I get is the mold, and it is also guaranteed to hang on the chest and say that there is no problem. After getting the mold, the whole thing is dumbfounded ~ The mold surface is rough and the handle is very easy to grip In the last four molds, two molds believe that they have lost their heads. It was difficult to hand over the aircraft, and it took a few days to start. Just because the motor lacked horsepower, it was hung back to the factory for maintenance. After the overhaul, the payment and acceptance of the aircraft began to be urged. So far, less than a year of use. The wear of the machine itself is not counted. Just because of the poor design of the machine itself, ask them to repair it three or four times The same problem, after coming to the site for repairs, I said to go back to make parts replacement After that, two months of indifference It wasn't until I took the initiative to call to ask, did I arrange someone to overhaul This time it said it would take two weeks. It should be 11/8 to repair OK ,,, at least this time I have notified in advance. The problem is that today it is 11/10, and I have not received any notice at all.

I would advise you all manufacturers to absolutely be careful when dealing with this company The proprietress and accountant will use various excuses to delay payment The money that should be paid procrastinates and washes your face with ugly words for various reasons Why is it so thick-skinned to delay the payment? ?? The reputation is bad enough, do you want to continue to suck? Is it hard to be a good person? I can only say that the big players in the industry who want to deal with this company You have to be careful! Otherwise it will be yourself ? Brush up negative reviews!